Page 9
Using your FLOE trailer
Proper Loading & Unloading
Loads should be placed on the trailer so that
proper weight is applied to the tongue. Increase
or decrease the tongue weight by moving the
load forward or backward. When possible, loads
should also be placed to distribute equal weight to
all tires to prevent poor towing, axle damage, and
unequal or premature tire wear. See the diagrams
below for suggested load placement and tongue
weight. Unlike many trailers, the advanced design
of your FLOE trailer requires very little tongue
weight in order to minimize sway and to track
smoothly behind your tow vehicle.
The illustrations below are for typical placement
of snowmobiles. Use this information and
common sense for placing other loads as well.
Tongue weights are not strict maximums or
minimums, they are recommended ranges that
work well for the illustrated loads.
Failure to follow the steps below when loading
or unloading could result in damage to your
trailer, tow vehicle, snowmobile, and/or cause
possible severe or fatal injury to yourself and
others.
CAUTION
1. Never load or unload your trailer unless it is
properly connected to your tow vehicle.
2. It is imperative that your tow vehicle and trailer
are parked on level, even ground. Loading while
parked on an incline or uneven ground could
cause your trailer bumper to be at an improper
angle. This could catch your ski and cause
damage to your trailer, snowmobile and/or cause
severe or fatal injury.
3. Never load at speeds greater than 5 mph.
4. Ensure the trailer is fully tilted and that it will
stay in the tilted position until you have driven
on to it.
5. After loading, make sure the tilt clamp is secure
and will not work itself loose while being
towed. Make sure the safety pin is attached.
6. Always test your footing before walking on the
trailer’s deck. It may get very slippery in cold,
wet and snowy weather.
10’ & 12’ Tilt
Tongue Wt. 45-100 lbs
Ideal: 70 lbs.
Utility
Tongue Wt. 25-80 lbs
Ideal: 50 lbs.
Using your FLOE trailer
Securing Ramp
Be sure that you tighten the crank handle firmly in
place each time you travel and each time the ramp
is put into it’s storage position.
Failure to firmly secure the ramp by tightening
the crank handle may result in the trailer ramp
becoming loose and falling out.
WARNING
Crank Handle
Be sure to securely
tighten crank handle
before each trip.
Summary of Contents for 500-95500-00
Page 31: ...Page 31...