SHEET 6 OF 12
THREAD THE END OF THE ADJUSTMENT BOLT INTO THE THREADED CABLE END OF THE
ADJUSTMENT CABLE UNTIL IT BOTTOMS OUT (FIGURE 1.10). TIGHTEN THE 3/8” NUT AGAINST THE
END OF THE CABLE END USING 9/16” & 7/8” WRENCHES TO HOLD THE CABLE WHILE TIGHTENING
THE NUT (FIGURE 1.11). RUN THE 3/8” ASJUSTMENT BOLT LOCK NUT AS FAR BACK AS POSSIBLE
TOWARDS THE HEAD OF THE ADJUSTMENT BOLT (FIGURE 1.12).
FIGURE 1.10
4X
FIGURE
1.11
4X
FIGURE 1.12
4X
Summary of Contents for 512-00040-00
Page 11: ...SHEET 11 OF 12 NOTES...
Page 12: ...SHEET 12 OF 12...
