FLORABEST 270725, Translation Of The Original Instructions

24

GB

Electrical safety:

  Warning! Do not use the tool 

if the mains or extension ca-

ble is damaged – danger of 

electrical shock.

•  Keep the mains cable away 

from the tines. Always trail the 

mains cable behind you or the 

person operating the tool. If the 

cable becomes damaged dur-

ing use, immediately disconnect 

it from the mains. 

  Never touch the mains cable 

before unplugging it from the 

mains.

•  Make sure that the mains volt

-

age matches the data on the 

tool’s rating label.

•  Avoid skin contact with earthed 

objects such as metal fences 

and posts.

•  Make sure that the connector on 

the extension cable is protected 

from splash water, and is made 

of rubber or has a rubber cover-

ing. Only use extension cables 

that are intended for outdoor 

use and are labelled as such. 

Use extension cables with a 

cable core diameter of at least 

one square millimetre. Always 

completely unwind the cable 

reel before use. Check the ca-

ble for damage.

•  Use the cable hanger fitted for 

the purpose when using an ex-

tension cable.

•  Do not carry the tool by the ca-

ble. Do not unplug the cable by 

tugging on it. Keep the cable 

away from heat, oil and sharp 

edges.

•  Connect the appliance to a 

power socket with a residual 

current circuit breaker of rated 

residual current no more than 

30 mA.

Assembly instructions

  Always disconnect the tool 

from the mains before con-

ducting any work on it. 

  While assembling the tool, 

make sure that the mains 

cable (2) does not become 

caught and has enough 

slack.

Fitting the grip tubing

B

 1.  Push the two fork grips (1a/1b) 

into the plastic cross-plate (3), 

and screw the plate into the 

corresponding holes in the grip 

tubing using the bolts provided 

(13).

2.  Screw both central tubes (4) onto 

the fork handles (1a/1b). To do 

this, push the enclosed screws 

(14) inwards through the holes 

and screw them in place with the 

wing nuts (15).

3.  Position the handle rod with the 

pipe ends to the left and right 

on the lower frame tubing (

A

6) and screw it in place with the 

enclosed screws (14) and wing 

nuts (15).

  When assembled correctly, the 

handle ends point away from the 

equipment  front with the ventilation 

slits (see 

A

 7).