37
GB
- Check for alignment of moving
parts, binding of moving parts,
breakage of parts, mounting and
any other conditions that may affect
its operation.
- A guard or other part that is dam-
aged should be properly repaired
or replaced by an authorized
service centre unless otherwise indi-
cated in this instruction manual.
- Have defective switches replaced
by an authorized service centre.
- Do not use the tool if the switch
does not turn it on and off.
There is a risk of injury.
•
Warning.
The use of any accessory or attach-
ment other than one recommended in
this instruction manual may present a
risk of personal injury.
•
Have.your.tool.repaired.by.a.
qualified.person..
This electric tool
complies with the relevant safety rules.
Repairs should only be carried out by
qualified persons using original spare
parts, otherwise this may result in con-
siderable danger to the user.
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.
Further Safety Instructions
• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and
saw chain. In the event that it is dam-
aged or severed, immediately discon-
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• Before use, carry out a visual inspec-
tion of the grinding disk. Do not
use grinding disks that are spalled,
cracked or otherwise damaged. Re-
place a worn grinding disk.
• Never operate the device without the
visual protection disk.
• Do not work with the device if you
are tired or after the consumption of
alcohol or tablets. Always take a break
from the work in good time.
• Do not use the device in an explosive
atmosphere or where sparks could
cause fire, explosion etc. Failure to ob-
serve this will result in a risk of fire or
explosion.
• Keep your hands away from the grind-
ing disk and chain teeth when the
device is in use. Do not move the chain
by hand. This will cause a risk of in-
jury.
• Never place your fingers between the
grinding disk and rotary disk or be-
tween the grinding disk and protection
disk. This will cause a risk of crushing.
• The chain becomes hot during grind-
ing. Do not touch the machined loca-
tion, as there is a risk of being burnt.
• Use only grinding disks recommended
by the manufacturer. Do not use saw
blades.
• Switch off the device and disconnect at
the plug
- to release a jammed insertion tool,
- if the connecting cable is damaged
or tangled,
- in the case of unusual noises.
