36
GB
the same or a similarly qualified person in
order to prevent hazards.
• Do not use the appliance if the on/off
switch does not work properly. Always
have a damaged switch repaired by our
Service Centre.
• Only use extension cables that have been
approved for outdoor use and are resist-
ant to splash water. The core diameter for
extension cables measuring up to 25 m
must be at least 2.5 mm², and 2.5 mm²
for cables longer than 25m. Always roll
the whole cable off the reel before use.
Check the cable for damage.
• Do not unplug the shredder by the cable.
Keep the cable away from heat, oil and
sharp edges.
Installation manual
Unpacking
1. Remove the shredder from the
packaging.
B
2. Pull the collector box (2) out of
the chassis (12) and take out the
shredder unit and accessories.
3. Check the scope of delivery.
Assembling the shredder
C
1
Assemble the two running wheels
(1). Clip in the wheel covers into
the running wheels.
2
Screw on the two adjustable feet
(13) to the chassis (12).
3
Fix the cutting attachment (4)
onto the chassis (12) with the four
screws enclosed.
4. To insert the collector box
(
A
2), the safety switch(see pic-
ture
D
) must be unlocked, i.e. in
the “OFF” position. Push the col-
lector box (
A
2) into the chassis (
A
11), with the safety switch (
A
3) on the side of the wheels (
A
1). The collector box (
A
2) can
be pushed in only in one direc-
tion.
5. Lock the collector box (
A
2) by
pushing the safety switch (Fig
D
) to the ON position.
Operation
Start-up
Before starting the shredder, make sure that
the shredder unit is firmly attached to the
chassis and the collector box and safety
switch are in their proper positions (Fig
D
).
The shredder cannot be switched
on before the collector box and
safety switch are in their proper po-
sitions.
Switching the shredder on and
off
Make sure that the mains power
voltage agrees with the type plate
on the shredder.
Make a loop at the end of
the extension cable and
hang the loop onto the strain
relief on the mains cable (
A
5).
Connect the extension cable.
Make sure that the funnel feeder is empty.
1. To switch on, push the operating mode
selection switch (
A
9) lock forward
Summary of Contents for 73432
Page 3: ...C D B A 1 2 7 5 11 3 8 6 12 9 4 10 ON OFF 3 1 2 3 12 2 3 12 4 1 13 12 13 3...
Page 46: ...14 15 16 17 18 E...
Page 47: ......
