12
GB
To reduce wear on the collec-
tion bag, do not drag it along the
ground while working.
If the device stops suddenly dur-
ing operation and does not pro-
duce any suction, then it is to be
switched off immediately. Pull out
the power plug and make sure
that no material is wedged in be-
tween the shredder impeller and
the casing. Carry out the work as
described in the chapter “Cleaning
and Maintenance”. If the appliance
will not start, consult our Service
Centre.
Emptying the collection bag:
With full collection bag, the suction pump-
ing capacity decreases considerably and
the collection bag must be emptied when
the bag is full or interferes with the suction
capacity of the device.
Disconnect the device and pull out
the power plug before emptying
the collection bag. Danger of elec-
tric shock!
1. Wait until the impeller wheel comes to
a standstill.
2. To remove the collection bag, remove
the retainer loop (No.
B
19) and
press the coupler lever on the frame
(No.
B
17).
3. Open the zip-fastener on the collec-
tion bag and empty it completely.
4. Mount the emptied collection bag
again (see also assembly instruc-
tions).
Composting material does not be-
long with domestic waste!
Cleaning and maintenance
Pull out the power plug before all
work on the device.
Leave all work not described in
this manual to our Service Cen-
tre. Only use original parts.
Before every use, check the leaf blower
for obvious deficiencies, such as loose,
worn or damaged parts and for correct
seating of the parts. Replace damaged
parts. Check the bag regularly for wear
and tear.
Carry out the following maintenance and
cleaning work regularly. By this means, a
long and reliable life is guaranteed.
General cleaning
Clean the device in each case
immediately after working, since
otherwise mud with leaf residues
hardens and sets
and can pos-
sibly no longer be removed without
dismantling the motor casing.
Such cleaning work is not cov-
ered by the guarantee
.
Do not employ any cleaning agents
or solvents. They can irreparably
damage the device. Chemical sub-
stances can attack the plastic parts
of the device.
• Clean the device casing, the tube and
the ventilation slots regularly with a
soft brush or a cloth. Never clean the
device under running water.
• Take off the collection bag after finish-
ing work, turn it inside out and brush it
thoroughly. In this way, you avoid the
Summary of Contents for FLB 2500 A1
