background image

User manual                                       FLORIDA stove                                             Creina d.d.

3.1.

Ignition procedure

o

Open both primary and secondary air-inlet 
regulators (see picture bellow)  

o

Fully open flue by-pass device (if present).

o

Open the firedoor.

o

After you have put in several ignition material 
(thin wood, ignition cubes, scrambled paper…)
into combustion chamber, insert 2-3 pieces of 
firewood (chopped) on top of it. Please fill 
stove with care to avoid potential damage.

o

Ignite the ignition material and close the 
firedoor.

o

After stove heats up (it usually takes up from 5 
to10 minutes), close primary regulator.

o

Heat output is regulated by opening or closing 
secondary air-inlet regulator.

o

Nominal heat output (8 kW), is generated 
when:

o

primary regulator is set to fully closed

o

secondary regulator is set to fully open

o

there is an aprox. 2,5 kg of firewood inside
of stove

o

draught is at 12 Pa.

o

Some of the air, which is heated up inside of 
stove, is guided through the channels inside 
the stove, onto the firedoor glass, where it 
performs a cleaning (of the glass) (air brush 
cleaning principle). 

Attention: 

Certain types of stoves require 

somewhat longer ignition phase, until there is 
enough negative pressure (draught) for the stove 
to work on its own. When this is the case, use 
smaller, dried-up logs. Afterwards you can use 
bigger logs.
If firedoor is open during ignition phase, strong 
draught can cause fire to blaze up. High flames 

start to pound the firedoor glass, thus sooting it or 
even damaging it.

3.2.

Heating

o

Maximum capacity of the stove is 2,5 kg of 
firewood per hour.

o

Leave the fresh air connection flap (if present) 
open.

o

Fire intensity regulate with secondary air-inlet 
regulator.

o

For flue gases to be able to pass by, flue 
damper should never be fully closed.

o

Also, by closing the flue damper, you could 
cause bigger negative pressure inside the 
stove , which might damage the stove 
(overheating).

3.3.

Loading firewood

o

Fully open flue-damper (is present).

o

When opening firedoor, always use the 
enclosed protection gloves.

o

Open door slowly. 

o

Remember that maximum capacity is 2,5 kg of 
firewood per hour.

o

Close the firedoor.

o

Close the flue-damper (if present) to its 
operating position. 

o

Always keep the fire under control, to prevent 
possible fire accidents. Pay special attention if 
children are around.

4. CLEANING THE STOVE

4.1.

Warnings 

o

Never use water for fire extinction.

o

Cleaning should only be performed when stove
is fully cooled down. Remember - embers 
could remain in ashes, hours after the fire has 
been extinguished.

o

When cleaning, always wear protection gloves.

o

Open firedoor

o

Remove debris from combustion chamber.

o

Glass should be cleaned with special cleaning 
agent. (contact your local stove-supplier, 
regarding those cleaning agents).

o

If stove is being used properly, stove glass 
should remain clean (There is always a 
possibility that not all of conditions, for stove to
work properly, were met (some of the firewood 
might be wet, chimney conditions not perfect 
etc.), therefore glass might still soot up.

 V2.0                                                 Lokaterm

™ 

© 06/06                                                 page  5

secondary regulator

opened out

closed in

primary regulator

opened out

closed in

Summary of Contents for Lokaterm








Reviews: