Preparing to Start the Shallow Well Pump
12
Never run pump dry .
Running pump without water may cause
pump to overheat, damaging seal and possibly causing burns to persons
handling pump. Fill pump with water before starting.
Never run pump against closed discharge .
To do so can boil
water inside pump, causing hazardous pressure in unit, risk of explosion
and possibly scalding persons handling pump.
Step 1. Remove the priming plug from the pump and fill the pump, fill
all piping between the pump and the well, and make sure that all
piping in the well is full (see Figure 16). If you have also installed a
priming tee in the suction piping, remove the plug from the tee and
fill the suction piping.
Step 2. Replace all fill plugs.
Step 3. Power on! Start the pump. The pump should pump water in two or
three minutes.
Step 4. If you don’t have water after 2 or 3 minutes, stop the pump and
remove the fill plugs. Refill the pump and piping. You may have to
repeat this two or three times in order to get all the trapped air out
of the piping.
Step 5. After the pump has built up pressure in the system and shut off,
check the pressure switch operation by opening a faucet or two
and running enough water out to bleed off pressure until the pump
starts. The pump should start when pressure drops to 30 PSI and
stop when pressure reaches 50 PSI. Run the pump through one or
two complete cycles to verify correct operation. This will also help
clean the system of dirt and scale dislodged during installation.
Congratulations on a successful installation.
If you were unsuccessful, please refer to the Troubleshooting section or call
our customer service technical staff.
Remove fill
plug and fill pump
and suction piping
through priming tee.
Figure 16: Fill Pump through
Priming Tee
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
Summary of Contents for FP415515H
Page 44: ......
