FloTech Programmable Retain / Overfill Monitor
10464 REV C
9
4.
Fill a FloTech Butt Splice with Silicone RTV
compound. Insert the twisted wires into the filled splice.
Check to see that the bare wires are fully inserted into
the splice and RTV. Make certain that NO bare wire is
protruding from the splice.
5.
Securely crimp the wires into the butt splice.
6.
Give the splice and the wires a „tug‟ to make sure you
have a good mechanical connection.
TERMINAL BLOCK CONNECTIONS
Follow this process to secure each connection:
1.
Strip approximately 3/8 inch of insulation back from the
end of the wires.
2.
Tightly twist the strands of wire together.
3.
Rotate the terminal block screws counter-clockwise a
few turns to relieve pressure on the wire retainer.
4.
Insert the bare wire end into the terminal block.
5.
While holding the wire in place, rotate the terminal
screw clockwise to tighten the wire retainer.
6.
Once fully tightened, give the wire a slight „tug‟ to
insure that a proper connection has been made.
Monitor Wiring Connections
Before attaching wires to the FT203P Monitor, please read the
following:
CAUTION:
Turn off or disconnect power to the trailer before
wiring the monitor.
CAUTION:
Only use the conduit opening marked “POWER
INPUT” as shown in Fig. to wire power to the monitor.
CAUTION:
The FloTech FT203P Monitor will
NOT
work on
POSTIVE GROUND
electrical systems. Any attempt to wire
the monitor to a positive ground system will damage the
monitor and void the warranty.
