FloTech Programmable Retain / Overfill Monitor
10
10464 REV C
TB1 POWER Connections
Refer to Fig. 4. FloTech recommends routing the trailer power
through a weatherproof inline fuse holder containing a 1/2 amp
fast blow fuse to the monitor. Optionally, a switch can be
added in series with the fuse to the TB1 input. Connect the
positive power supply wire to the TB1 terminal marked “12/24
VDC”. This is the upper screw on TB1. Be careful that no
stray wires are touching the metal barrier or ground terminal.
The Power Ground wire connects to the TB1 terminal marked
GND.
Fig. 4
Monitor Power Connections
TB2 TOP and BOTTOM SENSOR Connections
FloTech recommends wiring the sensors to the FT203P Monitor
using FT401 seven wire cable using color code shown in Fig.5.
Complete wiring schematic is shown in back of this booklet.
Fig. 5
TOP and BOTTOM Sensor Connections
