63
Problem:
The console / display will not turn on.
Solution:
- Check if the treadmill is pugged into a grounded outlet.
- Check if the
0 /
I
switch is on (
I
). The switch is near the power cord on the
near the motor cover.
- Check the fuse near the switch. If the fuse is broken, please contact your
dealer.
Problem:
Segments of the display don’t light up.
Solution:
LEDs of the display are damaged; please contact your dealer.
Problem:
display shows “- - “.
Solution:
The safety key is missing. Place the key into the designated place to use the
treadmill.
Problem:
The treadmill is running rough.
Solution:
There is not enough lubricant between the belt and the running surface.
The treadmill should be lubricated at regular intervals.
Problem:
The running belt slips on the rollers.
Solution:
The belt needs to be tensioned. How to tensioning the belt is described in
chapter 4.2.
Problem:
When touching metal parts of the treadmill static electricity is released.
Solution:
- The treadmill should be powered by an grounded outlet.
- The running surface needs to be lubricated. Friction is created between the
belt and running board. This causes static energy and can be prevented by
regular lubrication.
Problem:
The display shows error code
E1.
Solution:
An abnormal value is send to speed sensor. Perform the following steps:
1. Remove power from the treadmill (by unplugging the product from the
outlet), wait 10 seconds before turning on the power again.
2. Press
START/STOP
and check the following:
a. Does the belt starts to move?
b. If the belt is moving, is the error code
E1
still in the display?
3. If the treadmill is running correctly, tension the belt again and lubricate the
running surface (chapter 4.4 of this manual)
If the belt is not running or error code
E1
is still visible, please contact your
reseller.
5.3 Troubleshooting
5. General information