64 - Flow Fitness PERFORM X2i - User Manual
6
Product information
During a training the hometrainer makes beeping or scratching noises.
Beeping or scratching noise are mostly caused by the plastic cover hitting or scratching the metal frame. The solution to this problem
is to spray this components with WD40. WD40 is available in hardware stores.
De computer doesn’t or badly reads your heart rate.
Receipt of the heart rate with use of the handle bar sensors is not consistent. Sweat, movement or even hand creme can have a
negative effect on the connection. We advise you to use a bluetooth chest belt while training a heart rate controlled exercise program.
The handle bar sensors are primarily used for occasionally checking the heart rate during a training excises.
When there is no heart rate reception when using a bluetooth chest belt check the following:
- Have you read the chest belt’s manual? It is important that the sensors are made moist for a better contact with the skin.
- Is there a full and correctly placed battery?
- Is the chest belt worn tight enough?
I cannot get a connection between my device and Kinomap
You must first create an equipment in Kinomap, go to the menu and choose equipment, then you can add a device. If you have an
exercise bike, click on exercise bike. If you have gone through the steps, but you do not see the name of the device, see if you see
Fithiway or iconsole.
Troubleshooting
Problem
Solution
Problem
Solution
Problem
Solution
Problem
Solution
In case your problem is not resolved or not described, consult the fitness dealer where you purchased this product.
