6)
Install clamp hanger
#476HA
provided in the parts kit onto the rear of
the inlet pipe and leave loose. Connect the inlet of the muffler to the back of
the inlet pipe and support the muffler with a stand. Slide the
476HA
clamp
assembly over the muffler inlet and connect the hanger to the rubber mount
on the vehicle as shown, tighten the clamp enough to hold but still allow for
adjustment.
7)
At the rear of the frame on the drivers side of the vehicle there is a rectangular hole in the
outside of the frame. Using this hole, connect frame hanger
#474HA
to the outside of the frame
using the
#475HA
as a backing plate on the inside of the frame, secure with the nut and washers
provided. Make sure the hanger is straight up and down, and then tighten securely. Place rubber
hanger
#HA168
onto the bottom of frame hanger
#474HA.
8)
Install a provided 2½" clamp onto the right muffler outlet. Place the
right side tailpipe
#86195S
into position over the axle and slip into the right
side muffler outlet, while at the same time, connecting the hangers at the front
and rear of the pipe to the rubber mounts on the vehicle. Tighten the clamp
enough to hold, but still allow for adjustment.
9)
Install a provided 2½" clamp onto the left muffler outlet. Place the front
section of the left side tailpipe
#86194S
into the left side muffler outlet and
connect the hanger on the pipe to the rubber mount on the vehicle. Tighten
the clamp enough to hold, but still allow for adjustment. Place a second 2½”
onto the back of this pipe in preparation for the next step.
10) Connect the rear section of the left side tailpipe
#86196S
onto the back
of the front section by sliding the two sections together at the slip-fit
connection over the rear axle. Place the hanger at the rear of the tailpipe into
the rubber mount installed in Step 7 above. Tighten the clamp enough to
hold, but still allow for adjustment.
11)
Slide either the side exit pipe
#86197S
or the rear exit pipe
#86206S
onto the ends of both over-axle pipes. Place a 2 1/2" clamp onto these slip-fit
connections. Tighten enough to hold, but still allow for adjustment. Place the
two stainless tips
#ST461
onto the exit pipes and tighten the clamps enough
to hold, but still allow for adjustment. Rotate the exit pipe and tip to the
desired distance from the fender or bumper and so angle cut on tips are in the
desired location.
Pg 2 of 4
Technical Support (707) 544-4761
