8)
Slide either the side exit pipe
#86325S
or rear exit pipe
#86326S
onto the ends of both over
axle pipes. Place a clamp onto these slip-fit connections and tighten just enough to hold in position.
Place the two stainless tips
#ST461
onto the exit pipes and tighten the pinch bolts just enough to hold
in position. Rotate the exit pipe and tip to the desired distance from the fender or bumper so that the
tips are in the desired location. The final adjustment of the tips is best left to the final step, with the
vehicle on the ground so that you can get a good view.
9)
Now go back and adjust the position of all pipes and muffler to provide a satisfactory fit. A
minimum of 3/4” clearance around all parts of the system must be maintained; while keeping
suspension travel and vibration in mind. After adjustments have been made, you may now securely
tighten all clamps, including the front hanger/clamp assembly.
10)
After the system is secure, slide the 7/16” hanger keeper onto the left tailpipe hangers. This
keeper will prevent the hanger rods from slipping out of the rubber mount.
PACKING LIST
Qty
Description
Part#
1
Inlet Pipe
26532S
1
Adapter Pipe
26277S
1
Muffler
8530452-176
1
Right Tailpipe
86327S
1
Left Tailpipe, Front
86323S
1
Left Tailpipe, Rear 86324S
2
Side Exit Pipes
86325S
2
Rear Exit Pipes
86326S
2
Stainless Tip
ST461
1
Parts Kit
PK800
1
Ring Clamp Hanger
490HA
1
Frame Hanger, Rear
226HA
5
2 1/2” Band Clamp
MC250BS
2
3” Band Clamp
MC300BS
1
Rubber Hanger
HA168
1
Back-up plate
HA226
2
7/16” Hanger Keeper
HW502
1
3/8” x 3.50” Tap Bolt
HW234
2
3/8” x 2” Bolt
HW211
4
3/8” Flat Washer
HW303
3
3/8” Nut
HW103
3
3/8” Lock Washer
HW309
Pg 3 of 4
Technical Support (707) 544-4761