5
Place a supplied clamp onto both muffler outlets. Place the right side tailpipe
#26473S
into
position over the rear axle and into the right side muffler outlet. Connect the hangers at the front and
rear of the pipe to the rubber mounts on the vehicle. Tighten the clamp enough to hold but still allow
for adjustment.
6)
Place the front section of the left side tailpipe
#26474S
into the left side muffler outlet and
connect the hanger on the pipe to the rubber mount on the vehicle. Tighten the clamp on the muffler
outlet enough to hold but still allow for adjustment.
7)
Place a supplied clamp onto the expanded end of the rear section of the left side tailpipe
#26475S,
place
onto the back of the front section by sliding the two sections together at the slip-fit
connection over the rear axle. Place the hanger at the rear of the tailpipe into the rubber mount
installed in step 4 above. Tighten the clamp enough to hold but still allow for adjustment.
8)
Slide either the side exit pipe
#26471S
or the rear exit pipe
#26476S
onto the ends of both
over-axle pipes. Place a 3" clamp onto these slip-fit connections. Tighten enough to hold, but still
allow for adjustment. Place the two stainless tips
#ST462B
onto the exit pipes and tighten the clamps
enough to hold, but still allow for adjustment. Rotate the exit pipe and tip to the desired distance from
the fender or bumper and so angle cut on tips are in the desired location.
Adjust the position of all pipes and muffler to provide a satisfactory fit. A minimum 3/4” clearance
around all parts of the system must be maintained; while also keeping suspension travel and vibration
in mind.
Tighten all clamped connections down securely. Slide the 7/16” hanger keepers onto the end of the
hangers at the rear of the vehicle on the driver’s side to prevent the hangers from slipping out of the
rubber mounts. Also, use the included zip-tie to tie back the rear end breather tube and other cables
out of the way to provide clearance for the left side tailpipe, be sure to leave enough slack for
suspension travel.
For a more secure installation, we recommend welding all slip-fit connections.
