GEI 56128-L
© Copyright 2016 General Electric Company
3
D.
Description of Labels and Nameplates
Motor rating and identification data are furnished on labels and nameplates. Packing nameplates provide a
permanent record of motor characteristics, plant identification and date of manufacture. Below is an example of a
label that is attached to the shipping package.
E.
Model and Serial Numbers
As discussed in section D, every motor that is manufactured by GE Energy has a model and serial number, which are
permanently marked on the motor nameplate. When contacting a GE Energy Service Shop or representative, please
provide to the model and serial numbers.
Data and information regarding an individual motor model can be obtained from the Data Pack for the motor or
through EliteNet or by contacting your local GE Energy representative.
F.
Relevant Standards
1.
Motors shipped with this installation instruction have been designed and built to the latest revision of the
following standards:
a.
NEMA MG-1
2.
Motors that have the IECEx designation have also been designed to meet the requirements of the
following standards:
a.
IEC and/or BS/EN 60079-0
b.
IEC and/or BS/EN 60079-15
3.
Motors with the CE Mark have also been designed to meet the requirements of the following EU
directives:
a.
Machinery safety
b.
Low Voltage
c.
Electromagnetic Compatibility
d.
Conformity Assessment
II.
RECEIVING
Each shipment should be carefully inspected upon arrival. Motor rating and identification data are furnished on a
packing label for verification purposes. Any damage should be reported promptly to the carrier and a claim filed. The
nearest GE Energy sales office may provide additional guidance.
A.
Unpacking
If the motor has been exposed to low temperatures, unpack it only after it has reached the temperature of the room in
which it will be unpacked. Otherwise the motor windings will be exposed to condensing moisture.
MOD – GE model number
KW = Motor power rating
RPM = Motor speed at full
load
VOL – Motor voltage
ENCL = Enclosure code
FR = Frame size
MASS = Motor mass
SERIAL = Motor serial number
Figure 1: Packing Label
