FM USER INSTRUCTIONS ENGLISH 71576526 - 03/07
Page 29 of 32
flowserve.com
8.2 Sectional drawing parts list
ITEM
NOMENCLATURE
1130
Suction casing
1140
Discharge casing
1150
Stage casing
1410
Diffuser
1470
Diffuser plate
2250
Radial impeller
2410
Interstage sleeve
2450
Shaft sleeve
2540
Thrower
2905
Washer
2910
Shaft nut
4120
Gland
4130
Gland packing
4132
Stuffing box bushing
4590
Gasket
4610
O-ring
6515
Drain plug
6571
Tie bolt
6572
Stud
6577
Hexagon head bolt
6578
Threaded plug
6581-01
Hexagon nut
6581-02
Hexagon nut
6700
Key
6812
Grooved pin
8020
Motor for close coupling
9331
Cover plate
8.3 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be
sent to the Purchaser separately unless the contract
specifically calls for these to be included into the
User Instructions. If required, copies of other
drawings sent separately to the Purchaser should be
obtained from the Purchaser and retained with these
User Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
manuals
Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system etc
are provided as separate documents in their original
format. If further copies of these are required they
should be obtained from the supplier for retention
with these User Instructions.
10.2 Change notes
If any changes, agreed with Flowserve, are made to
the product after its supply, a record of the details
should be maintained with these User Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotor dynamic Pumps: a reference guide,
Euro pump Guide No. 1, Euro pump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature,
Definitions, Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.
