background image

TO REORDER REFER TO
B/M #
F.O

.

FIS230eng ORG 08/16 Printed in USA

Flowserve Corporation has established industry leadership in the design and manufacture of its products. When 

properly selected, this Flowserve product is designed to perform its intended function safely during its useful life. 

However, the purchaser or user of Flowserve products should be aware that Flowserve products might be used 

in numerous applications under a wide variety of industrial service conditions. Although Flowserve can provide 

general guidelines, it cannot provide specific data and warnings for all possible applications. The purchaser/user 

must therefore assume the ultimate responsibility for the proper sizing and selection, installation, operation, and 

maintenance of Flowserve products. The purchaser/user should read and understand the Installation Instructions 

included with the product, and train its employees and contractors in the safe use of Flowserve products in connection 

with the specific application.

While the information and specifications contained in this literature are believed to be accurate, they are supplied for 

informative purposes only and should not be considered certified or as a guarantee of satisfactory results by reliance 

thereon. Nothing contained herein is to be construed as a warranty or guarantee, express or implied, regarding any 

matter with respect to this product. Because Flowserve is continually improving and upgrading its product design, 

the specifications, dimensions and information contained herein are subject to change without notice. Should any 

question arise concerning these provisions, the purchaser/user should contact Flowserve Corporation at any one of 

its worldwide operations or offices.

flowserve.com

To find your local Flowserve representative

and find out more about Flowserve Corporation, 

visit www.flowserve.com

©  2016 Flowserve Corporation

 

USA and Canada
Kalamazoo, Michigan USA
Telephone: 1 269 381 2650
Telefax: 1 269 382 8726

Europe, Middle East, Africa
Roosendaal, the Netherlands
Telephone: 31 165 581400
Telefax: 31 165 554590

Asia Pacific
Singapore
Telephone: 65 6544 6800
Telefax: 65 6214 0541

Latin America
Mexico City
Telephone: 52 55 5567 7170
Telefax: 52 55 5567 4224

Summary of Contents for HSH Series









Reviews: