page 5
ASSEMBLY CONTINUED
#10 x 1/2" Screw and
#10 Flat Washer
4. Attach Funnel to Upper Housing
Align four (4) holes in Funnel with four holes in
Housing and fasten securely using four #10 x
1/2” screws and #10 flat washer as shown in
cutaway view in figure 7.
FIGURE 7
FIGURE 6
3. Assemble Funnel
Assemble funnel with tabs on outside and screw
together in two places using 10-32 x 3/8” screws
and 10-32 hex nuts. Place screw heads on
inside with nuts on outside.
Tinnerman Clip
(three places)
FIGURE 5
1. Assemble Upper and Lower Housing
Install the three Tinnerman Clips onto the edge
of the Lower Housing in areas provided. Place
both Upper Housing and Lower Housing upside
down and align the slot in the edge of the Upper
Housing with the tab on the Lower Housing.
Push the Lower Housing down until it is seated
firmly in the Upper Housing. Position the
assembly in the upright position and fasten both
housings together using the three #10 x 5/8”
sheet metal screws as shown in Figure #5.
