Flowzone Silica Slayer, Operation Manual

Required tools: Phillips head screwdriver

Before you begin, open the tank lid (1) and remove 

the nuts and bolts, holsters, and nozzles from inside 

the tank strainer (3). Set aside. 

Bring the ComfortStraps™  (5) to the bottom of the 

tank (2). Secure lower strap clips to the tank loops 

near the bottom of the tank. 

Next, slide the  adjustable strap through the 

top tank loop. Continue by sliding the strap 

over and under the buckle fitting. Lightly tug 

at the strap to make sure it’s secure. Repeat on  

other side.

Place the top wand holster (4) on the molded holster 

bracket on the tank. While holding the holster, place  

nut on one side of the hexagonal slots and screw 

the bolt through the other side until it fastens into 

the nut. 

Repeat for other slot and bottom holster.

Take  the  spray  gun  (8)  and  attach  it  to  the  GHT 

fitting on the end of the hose (7). Tighten the fitting 

to ensure the gasket properly seals the connection.

If spraying with the stainless-steel spray wand (6), 

pull back on the collar of the quick-connect fitting on 

the spray gun. Insert the male wand fitting into the 

female spray gun fitting and push the collar back 

into its original position. Nozzles can be attached 

with the same process.

Snap the spray wand into the wand holster and 

place any unused nozzles into their slot until ready 

to spray.

A) 

B) 

C) 

E)

F)

G)

STEP 1.

ASSEMBLING YOUR NEW SPRAYER

D)

Copyright © WESSOL, LLC

10