Inst464
–
Viron e-Quilibirum Series Chlorinator Instructions V07-20
26
9.1 REGULAR MAINTENANCE
Your Viron e-Quilibrium Chlorinator requires regular maintenance to sense the chlorine and pH levels
accurately and to safely dose the pH adjuster (hydrochloric acid).
Frequency
Maintenance Description
Weekly
Check Acid level and replace or top up as required
Monthly*
Manual test for pH and chlorine and adjust eQ set point
as required
Every 3 Months
Spray a surface insecticide on the surfaces around the
unit to prevent ant and insect ingress.
To protect against extremes of temperature, your unit is
vented to allow expensive electronics to cool. Ants and
some insects are often attracted to the warner, dry
environment inside the enclosure. We recommend that,
with power turned off, you spray a surface insecticide on
the surfaces surrounding the control to prevent ant and
insect ingress. Repeat every three months or as
necessary.
Twice Yearly***
Using a cotton bud and Jiff (non abrasive cleaner) clean
pH. Rinse in clean water or clean pool water. Re install,
allow 24 hours to settle and sense correct levels. Adjust
set points or calibrate sensors as required
Twice Yearly***
Inspect Acid tube, peristaltic pump squeeze tube
condition for cracks, wear and tear. Replace as required
Monthly*
Test and adjust Total Alkalinity, CyA levels, and
Calciium Hardness levels and adjust to levels
recommended by your professional pool shop or service
technician
* AstralPool recommend your water tests are conducted by a professional pool shop or service
technician. Use a clean sample bottle and take sample from approximately 30 cm below water level.
Take sample to pool shop immediately. Water Sample bottles can usually be obtained from your local
professional pool shop.
***We recommend you engage a pool professional to test, clean and calibrate your pH and chlorine
sensors.
