After a few second this screen will be displayed.
This screen is displayed on the first execution of the software, the software will automatically
scan and a progress bar will be shown as in the screenshot above (ensure that FUJITSU fi-
60F is the scanner selected).
In the screen shot above you will see an image of what the scanner has captured. You will
notice a yellow box with a square at each of its four corners. This box should be aligned with
each of the corners of the rack containing the tubes.
If it is not aligned use the
mouse
to point to one of the yellow boxes that is not on the corner
of the rack,
left click the mouse and drag
the yellow box until it is over the corner of the
rack that it was nearest to. Repeat this operation until all four yellow boxes are on the
corresponding corners of the rack.
Before we leave this screen please make sure the correct tube manufacturer has been
selected. You can change tube manufacturer by simply
left mouse button clicking
the
radio button
that is to the left of the tube manufacturer’s name. This section is located to
the right of centre and towards the bottom of the
dialog box
the section is tilted “Tube
manufacturer”.
We will explain about the other settings on this screen later in this manual. Please
left
mouse click
the
OK button
located at the bottom of the
dialog
box
to save and exit.
8