56x
Users Manual
22
Maintenance
Battery Charge
Use the battery charge symbols to gauge the approximate level of charge left on
the batteries.
Notes
When in low battery mode, the thermometer does not store values.
“Err” appears on the display if attempted.
Batteries are at 5 %. Before taking further readings, the batteries
must be changed.
Changing the Batteries
W
Warning
Batteries contain hazardous chemicals that can cause burns or
explode. If exposure to chemicals occurs, clean with water and
get medical aid. To prevent injury and for safe operation and
maintenance:
•
Remove all probes, test leads, and accessories before the
battery door is opened.
•
Do not disassemble the battery.
•
Repair the Product before use if the battery leaks.
•
Remove batteries to prevent battery leakage and damage
to the Product if it is not used for an extended period.
•
Be sure that the battery polarity is correct to prevent
battery leakage.
•
Do not short the battery terminals together.
•
Do not disassemble or crush battery cells and battery
packs.
•
Do not keep cells or batteries in a container where the
terminals can be shorted.
•
Do not put battery cells and battery packs near heat or fire.
Do not put in sunlight.
Note
The batteries should be replaced in less than one minute after
removal to avoid manually re-initializing the thermometer clock and
date.
To install or change the two AA batteries (see Figure 10):
1. Slide the locking tab on the battery door to the “unlock” position and then
open the handle.
2. Insert the batteries noting their correct polarity.
3. Close and lock the handle.
Shop for Fluke products online at:
1.877.766.5412
www.
MyFlukeStore
.com
