20
576
Using the Camera (Model 576)
In addition to the thermometer functionality the
Model 576 comes with a digital built-in camera
to documentate the measured places. The
pictures include the measured values and
additional information. the additional information
is customizable via the IRGraph software.
How to use the camera?
1. To switch on the unit, pull the trigger.
2. Press the “Enter” button to activate the
camera while the display is active.
3. First the word “LOG” flashes and then the
camera icon appears.
The unit is ready to use now. It is preset to
take 26 high-resolution (640x480 pixel)
pictures.
4. Pull the trigger and hold it. The laser circle
shows where you are measuring.
5. Aim at the target. Be sure that the laser
sighting is inside the target.
6. Gently release the trigger to record the
photo and the temperature. Successful
recording of picture and temperature is
indicated by two short beeps and a green
blinking LED above the display. The next
location will be shown on the display.
Caution:
If you hear a longer beep and the LED
above the display is shining red, look at the
display. If you see “Use Flash!” and a flash
symbol, repeat your last measurement.
A green LED above the camera symbol
