XS, XST
Users Manual
18
Pause/Save
To pause and save a target area image:
1.
Follow the procedure under Scan Target.
2.
When an area of interest is visible on the display screen, pull and
release the Frame Capture Trigger. The image on the screen freezes
for approximately 2-3 seconds and is saved to the Camera internal
memory. The image ID number and number of saved images in the
camera memory is displayed in the upper left corner of the display
screen. See Naming Image Files later in this Manual.
To retain the saved image on the display screen for further review, do not
release the Frame Capture Trigger when capturing the image. The Camera
automatically returns to the Scan Target mode once you release the Frame
Capture Trigger.
Review Images
To view images saved to the Camera’s internal memory:
Note
Review Images mode must be started from the main menu. If there are
no saved images, “Review Images” does not appear in the main menu
and the Camera will start in Scan Target mode after releasing the
Frame Capture Trigger for 4 seconds with “Run Normally”
highlighted.
1.
If the Camera is ON, toggle the ON/OFF switch to the left to power
the Camera off.
2.
If the Camera is OFF, power the Camera on by toggling the ON/OFF
switch to the right, while simultaneously pulling and holding the
Frame Capture Trigger. This opens the main menu.
3.
From the main menu, pull and release the Frame Capture Trigger to
highlight “Review Images,” and then release the Frame Capture
Trigger for 4 seconds.
4.
View each saved image one at a time by repeatedly pulling and
releasing the Frame Capture Trigger. The images are displayed
beginning with the most recent image saved.
