TiX520, TiX560
Users Manual
32
Wireless Connectivity
The Imager is equipped with WiFi, Bluetooth, and
Bluetooth Low Energy wireless connectivity options.
Wireless connectivity enhances your ability to work more
efficiently and better communicate results. The Imager
ships with the radio disabled. For first-time use, you must
enable the radio to use wireless connectivity.
To enable the radio:
1. Connect the Imager to a PC with internet access and
Fluke SmartView software.
SmartView detects that the radio is disabled in the
Imager and prompts you to register at
www.fluke.com
and enable the radio.
2. When you opt in, SmartView opens up a browser
window to the Fluke registration web page. The web
page provides the Imager serial number, choice of
radio, and UI language.
3. Type the registration information into the web page.
The server checks if the radio can be enabled for this
address. If yes, a passphrase is provided to paste into
SmartView.
SmartView validates that the passphrase is correct and
then enables the radio in the Imager.
Bluetooth
®
Bluetooth is available to connect a device such as a
wireless headset. When on,
shows on the display
(upper left corner).
WiFi™ Hotspot
You can wirelessly send a picture from the Imager to a PC,
an iPhone, and an iPad through the WiFi connection. A
transferred image can be viewed with Fluke Connect™ or
SmartView Analysis and Reporting software if installed in
the device.
WiFi™ Network
Infrastructure WiFi is a wireless local area network
(WLAN) that links your Imager to other wireless devices
using its radio and providing a connection through an
access point to the wider Internet. This gives you the
ability to move around within a local coverage area and
still be connected to the network.
Summary of Contents for TiX520
Page 6: ...TiX520 TiX560 Users Manual iv ...
Page 8: ...TiX520 TiX560 Users Manual vi ...
Page 10: ...TiX520 TiX560 Users Manual viii ...
Page 56: ...TiX520 TiX560 Users Manual 46 ...
