TiX520, TiX560
Users Manual
40
How to Clean the Case
Clean the case with a damp cloth and a weak soap
solution. Do not use abrasives, isopropyl alcohol, or
solvents to clean the case or lens/window.
Battery Care
Warning
To prevent personal injury and for safe operation
of the Product:
•
Do not put battery cells and battery packs near
heat or fire. Do not put in sunlight.
•
Do not disassemble or crush battery cells and
battery packs.
•
Remove batteries to prevent battery leakage
and damage to the Product if it is not used for
an extended period.
•
Connect the battery charger to the mains power
outlet before the Product or battery.
•
Use only Fluke approved power adapters to
charge the battery.
•
Keep cells and battery packs clean and dry.
Clean dirty connectors with a dry, clean cloth.
Caution
To prevent damage, do not expose Product to
heat sources or high-temperature
environments such as an unattended vehicle
in the sun.
To get the best performance from the lithium-ion battery,
use the guidelines that follow:
•
Do not store the Imager on the charger for more than
24 hours as reduced battery life may result.
•
Charge the Imager for a two-hour minimum at six-
month intervals for maximum battery life. Without use,
the battery will self-discharge in approximately six
months. Batteries stored for long periods will need two
to ten charging cycles for full capacity.
•
Always operate in the specified temperature range.
•
Do not store the batteries in extreme cold
environments.
•
Do not attempt to charge the batteries in extreme cold
environments.
Caution
Do not incinerate the Product and/or battery.
Summary of Contents for TiX520
Page 6: ...TiX520 TiX560 Users Manual iv ...
Page 8: ...TiX520 TiX560 Users Manual vi ...
Page 10: ...TiX520 TiX560 Users Manual viii ...
Page 56: ...TiX520 TiX560 Users Manual 46 ...
