4
4. To avoid injury, do not come into contact with moving parts or hot parts such as heaters, LED devices, etc.
5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply before placing hands in
water, before putting on or taking off parts and when this LED Strip Light is being installed, maintained or handled. Never
yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
Always unplug an appliance from an outlet when not in use.
WARNING: BE SURE YOU UNPLUG THE LED DRIVER FROM THE POWER OUTLET; JUST SWITCHING OFF THE
APPLIANCE WITH THE APP IS NOT ENOUGH BECAUSE IT DOES NOT STOP THE POWER SUPPLY.
Do not use this appliance for any purpose other than its intended use (i.e. don’t use in swimming pools, garden ponds,
bathtubs, etc.). The use of attachments not recommended or sold by the appliance manufacturer may result in a dangerous
situation. Do not try to repair any product component: in case of damage, replace the damaged component with genuine spare
parts.
6. IMPORTANT: This LED Strip Light is an AQUARIUM LUMINAIRE suitable FOR INDOOR USE ONLY designed to be
assembled onto Fluval Shaker Aquariums only. For fresh and salt water ornamental aquariums with max 35°C water
temperature. Do not install or store the appliance anywhere where temperatures may drop below freezing.
7. IMPORTANT: Make sure that the LED Strip Light is securely and correctly installed before operating. This LED Strip Light
must never operate in water.
Fill the aquarium up to the level indicated on the label situated on the inside of the aquarium (see the
image on the right). IMPORTANT: Do not overfill.
Overfilling the aquarium can cause water to pass under the top frame which then runs down
the outside of the aquarium.
WARNING: Do not plug in the LED Strip Light if there is water on parts not intended to be wet.
WARNING: Do not place any object(s) on the LED Strip Light (C) or on the cover. Ensure sufficient airflow around
the LED Strip Light. The safety of this appliance is only ensured provided that it has been properly installed.
8. Read and observe all the important notices on the appliance.
9. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than
the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
10. SAVE THESE INSTRUCTIONS.
FOR USA ONLY
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Change or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
max
