FDXD-6R-16L User Manual
(1) Please switch on the transmitter first,
then power on multi-rotor
(2) After MC powered on, avoid shaking the aircraft before
{ }
（
10
）
finishes,
otherwise it may lead to poor flight attitude
(3) Observe the LED status, wait until the GPS status is normal, then move on to
the next step
(4) Flip the CH5 stick to top and bottom quickly for several times, make sure the LED
indication corresponds with position of mode setting
Step3.
Low-altitude test flight
(1) Pull the left and right stick to the lower right corner in attitude mode, the motor
unlocked and starts from No.1 by turn.
(2) After the motors start, apply the throttle to 30% slowly, and then try to
push your sticks lightly in Roll, Pitch and Yaw to feel if your multi-rotor moves
to the corresponding direction. If ok, all sticks (except throttle stick) return to center,
continue to push the throttle until the aircraft takes off.
(3) Feel every channel operation at 2m below, if responding ok, you can explore
the best performance by yourself
After the flight, we must check whether the temperature of the motor and the reversing
motor is the same. If the temperature is inconsistent with each other, the aircraft may
have a load imbalance. Therefore, it is need to calibrate the level of propeller, in
order to ensure the consistency of the level of propeller.
Summary of Contents for FDXD-6R-16L
