“ KOMPRESS ” OWNER’S MANUAL REL . 2.2
___________________________________________________________________________
©
Copyright by
FLY
Products
s.r.l.
Page
25
Periodic maintenance is required in order to keep your
“KOMPRESS”
in top operating condition.
The following chart provides the suggested maintenance schedule.
After 5 minutes of
operation
Stop the engine and wait that for it to cool.
Check all bolts are tight.
After 30 minutes of
operation
Repeat the nut and bolt check. Verify the carburetion by the
colour of spark plug.
After 5 hours of
operation
Repeat all previous check every 5 hours.
After 25 hours of
operation
Replace spark plug with one of the same specification.
After 50 hours of
operation
Only for the version Easy pull starting: verify the correct
operation of the mechanical parts of the starting.
After 100 hours of
operation
Replace: engine block oil seals , piston rings, fibreglass insert
in the silencer, O-rings exhaust, belt reduction, bearings
pulley reduction, bearing pinion, spark plug.
Check: correct operation of the silent-blocks, internal
passages of carburetor.
After 200 hours of
operation
Repeat the replacement of all the pieces after the 100 hours
maintenance.
Remember…
…that YOU are ultimately responsible for your motor and it’s proper care,
FLY PRODUCTS and it’s
dealers assume NO responsibility for any engine problem resulting from improper use!
Before leaving the factory each motor has been tested for up to 30 minutes to insure that it is in proper
running order and all FLY PRODUCTS units are guaranteed up to twelve months after purchase.
The extraordinary maintenance or repairs will do only by authorized personal.
FLY PRODUCTS will replace any defective engine parts during the six months period after purchase.
Note that any electric parts that are damaged for improper use or modified in any way which could
cause an engine malfunction are not guaranteed.
7.0
MAINTENANCE
