Oblò / Oblò
-
A
/
P
(
Autopilot)
User’s manual
Flybox
72
Rev.3.7
®
6.2.1 SERVO/S CALIBRATION
The servo/s calibrations is GROUND BASED.
The calibration procedure is mandatory: if you try to
engage the autopilot without first calibrate the servo, the
Oblò will show the error message “AUTOPILOT
DISENGAGE! ROLL/PITCH SERVO CALIB”.
THE CALIBRATION MUST ALSO BE REPEATED IN
THE EVENT OF ANY CHANGES TO MECHANICAL
INSTALLATION OF THE SERVO/S.
Autopilot configuration
NOTE:
The “neutral position” terms used in the
following explanation means the center of the servo
arm travel relative to the position of the limiting
bracket:
Summary of Contents for Oblo
