USER MANUAL
INSTALLATION
Installation of the parachute cradle :
In order to be able to position the parachutes on the drone you must:
Unscrew the two landing gear supports
Position the cradle in place and place the cradle under the drone. Fix it with the 4 screws on each
side (USB connector towards the front).
Installing the Battery Butterfly :
In order to be able to lock the batteries with
the presence of the circuit breakers, it is neces-
sary to change the battery locking butterfly.
Place an adhesive tape on each side of
the push piece under the throttle valve to hold
it in place during disassembly.
Unscrew the central screw of the
throttle valve: CAUTION with the washers, re-
move the screw and the throttle valve.
Replace the screw in the new butterfly
valve, the washers and then screw.
Remove the adhesive tape.
Installation of the pyrotechnic charges :
Before setting up the «parachute» containers, please
place the two pyrotechnic charges on each side of the
drone on the intended locations (landing gear base, red
connector). Place the load correctly thanks to the two
lateral lugs.
FLYSAFE-M3
12/11/2020
FLYSAFE-M3
12/11/2020
Version 1.00
Hardware version 1.04
