5
EN
Product Installation Instructions
Step1. Take the product out of the box, remove
the outer PE bag, and place it on flat ground.
Step2. Take out the torx knob in the
accessories bag. Grasp the upright pipe by
your hand and and turn it up in the direction
of the arrow. After reach-ing the designated
position, use the torx knob and align it with the
screw hole to tighten it clockwise direction until
the upright pipe does not shake.(The same
method on the other side)
Step3. Take out the mobile phone holder and
safety lock from the accessory bag.Flip the
left and right armrest clockwise to level in the
direction of the arrow. Align the mobile phone
holder with the instrument panel and insert it
into the rectangular card slot. Place the safety
lock in the center of the yellow position.
Safety Key
Step4. Insert it into the frame tube socket
according to the direction, plug it in tightly,
insert the other end into the 120Vsocket and
turn the power switch to the symbol position
"—".After the light is on, you can start using the
product.
