v
Charge only lithium-ion batteries of the POWER FOR ALL system type
PBA 18V with a capacity of 1.5 Ah or more (5 battery cells or more).
The battery voltage must match the battery charging voltage of the
charger. Do not charge any non rechargeable batteries.
Otherwise there is a risk of fire and explosion.
v
Do not expose the charger to rain or wet conditions.
Water entering a power tool will increase the risk of electric shock.
v
Keep the charger clean. Dirt poses a risk of electric shock.
v
Always check the charger, cable and plug before use. Stop using the
charger if you discover any damage. Do not open the charger yourself,
and have it repaired only by a qualified specialist using only original
replacement parts.
Damaged chargers, cables and plugs increase the risk of electric shock.
v
Do not operate the charger on an easily ignited surface (e. g. paper,
textiles, etc.) or in a flammable environment.
There is a risk of fire due to the charger heating up during operation.
v
In order to avoid safety hazards, if the power supply cord needs to be
replaced, this must be done by FLYMO or by a customer service centre
that is authorised to repair FLYMO power tools.
v
Do not operate the product while it is charging.
Products sold in GB only: Your product is fitted with an BS 1363/A approved
electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not
suitable for your socket outlets, it should be cut off and an appropriate plug fitted
in its place by an authorised customer service agent. The replacement plug
should have the same fuse rating as the original plug. The severed plug must
be disposed of to avoid a possible shock hazard and should never be inserted
into a mains socket elsewhere.
v
These safety warnings apply only for lithium-ion batteries of the
POWER FOR ALL system PBA 18V.
v
Only use the battery with products of the POWER FOR ALL system
manufacturers.
This is the only way in which you can protect the battery against dangerous
overload.
v
Recharge only with the charger specified by the manufacturer.
A charger that is suitable for one type of battery pack may create a risk of
fire when used with another battery pack.
v
The battery is supplied partially charged.
To ensure full battery capacity, fully charge the battery in the charger before
using your power tool for the first time
v
Keep battery packs out of the reach of children.
v
Do not open the battery. There is a risk of short-circuiting.
v
In case of damage and improper use of the battery, vapours may be
emitted. The battery can set alight or explode.
Ensure the area is well ventilated and seek medical attention should you
experience any adverse effects. The vapours may irritate the respiratory
system.
v
If used incorrectly or if the battery is damaged, flammable liquid may
be ejected from the battery. Contact with this liquid should be avoid-
ed. If contact accidentally occurs, rinse off with water. If the liquid
comes into contact with your eyes, seek additional medical attention.
Liquid ejected from the battery may cause irritation or burns.
v
If the battery is damaged liquid can be ejected and cover nearby
surfaces. Check affected parts. Clean these parts or change them if
necessary.
v
Do not short-circuit the battery pack. When the battery pack is not
in use, keep it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal objects, that can make
a connection from one terminal to another.
Shorting the battery terminals together may cause burns or a fire.
v
The battery contacts can be hot after use. Be careful of the hot con-
tacts when removing the battery.
v
The battery can be damaged by pointed objects such as nails or
screwdrivers or by force applied externally. An internal short circuit may
occur, causing the battery to burn, smoke, explode or overheat.
v
Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorized service providers.
v
Protect the battery against heat, e. g. against continuous intense
sunlight, fire, dirt, water and moisture.
There is a risk of explosion and short-circuiting.
v
Only operate and store the battery at an ambient temperature
between – 20 °C and + 50 °C.
Do not leave the battery in your car in the summer, for example.
At temperatures of < 0 °C some devices may experience a loss of power.
v
Only charge the battery at an ambient temperature which is between
0 °C and + 45 °C.
Charging outside of this temperature range can increase the risk of damage
to the battery and pose a fire hazard.
v
After use, allow the battery to cool down for at least 30 minutes before
charging or storing.
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while it operates. This
field may under some conditions interfere with active or passive medical
implants. To decrease the risk of conditions that can possibly injure or
kill, we recommend persons with medical implants to speak with their
physician and the medical implant manufacturer before you operate the
product.
Remove the safety key before transportation.
Always remove the battery before storage.
Only use the battery product between 0 °C to 40 °C.
Do not use under wet conditions.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk that the poly-
bag can suffocate toddlers. Keep toddlers away when you assemble the
product.
Don’t open the protective flap while mowing.
Don’t reach through openings while using the mower.
Never cut grass by pulling the mower towards you.
Only use original spare parts.
Only start the mower when the handle is in the intended working position.
Do not use the start levers alternately.
Do not disassemble the product further than the delivery status.
Use gloves, wear slip resistant shoes and wear eye protection.
Do not overload the mower.
Never operate the product when you are tired, ill or under the influence of alcohol,
drugs or medicine.
Danger of slipping:
– in wet grass
– on steep slopes
– during transport
Be careful while going backwards.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v
Wait for the blade to stop, remove the battery, remove the
safety key and use gloves before you assemble the product.
To assemble the handle [ Fig. A1 / A2 / A3 ]:
1. Put the springs
(1)
on the shafts
(2)
.
2. Put the handle plates
(3)
on the shafts
(2)
.
3. Put the lower handle
(4)
on the shafts
(2)
.
4. Put the washers
(5)
on the shafts
(2)
and align with handle plate
recess.
5. Insert the bolts
(6)
into the quick-release levers
(7)
.
6. Screw the quick-release levers
(7)
loosely onto the shafts
(2)
and
clamp them down.
7. Put the upper handle
(8)
on the lower handle
(4)
and slide the
screws
(9)
through the boreholes (there are 2 holes in the lower
handle to choose the desired height).
8. Put the washers
(5)
on the screws
(9)
.
9. Insert the bolts
(6)
into the quick-release levers
(7)
.
10. Screw the quick-release levers
(7)
loosely onto the screws
(9)
and
clamp them down.
11. Attach the control cable
(10)
with the cable clips
(11)
.
To assemble the grass box [ Fig. A4 / A5 / A6 / A7 / A8 ]:
1. Push the grass box handle
(12)
into the slots (with the hook opposite
the grass inlet) in the grass box cover
(13)
until it audibly engages.
2. Slide the grass box tongue
(14)
into the slots in the grass box
(15)
until it
audibly engages.
3. Align the grass box cover
(13)
and the grass box locators
(16)
.
4. Fold the grass box cover
(13)
towards the grass box
(15)
.
5. Push the grass box cover
(13)
on the grass box
(15)
. Make sure that all
clips are snapped in correctly.
To attach the grass box to the lawnmower [ Fig. A9 ]:
1. Lift the protective flap
(17)
.
2. Attach the grass box
(15)
to the hooks
(18)
on the rear of the mower by
the handle
(12)
.
Make sure that the grass box is securely connected.
5
Page 2 width 2 mm less: 208 mm
22340-85.960.01.indd 5
22340-85.960.01.indd 5
20.11.21 16:44
20.11.21 16:44
