Problem
Possible Causes
Remedy
Filament is to short or trimmer
vibrates
Filament is jammed on the filament
cassette.
v
Rewind the filament to remove
crossed loops. Check that the fila-
ment is neatly winded. If it does not
help change the filament cassette.
Filament is broken inside the filament
cassette.
v
Replace the cutting filament.
Continuous clattering noise
Motor has not reached full speed
before use.
v
Allow the motor to reach full speed
before use.
Too much filament has been fed out.
v
Rewind the filament.
Filament limiter is missing.
v
Contact your local approved
Service Center or Husqvarna UK Ltd.
Customer Service.
Filament snaps continuously
You do not use the correct working
position.
v
Use the correct working position.
Filament is jammed on the filament
cassette.
v
Rewind the filament to remove
crossed loops. Check that the fila-
ment is neatly winded. If it does not
help change the filament cassette.
Poor performance
The cassette holder is dirty.
v
Clean the cassette holder.
For any other malfunctions please contact the Husqvarna UK Ltd. Customer Service.
Repairs must only be done by Husqvarna UK Ltd. service departments or specialist dealers
approved by FLYMO.
Unit
Value (CTE25)
Value (CTE27)
Value (CTE30)
Motor power consumption
W
500
580
650
Mains voltage
V
230
230
230
Mains frequency
Hz
50
50
50
Cutting filament thickness
mm
1.5
2.0
2.0
Cutting width
cm
25
27
30
Cutting filament supply
m
5
5
5
Cutting filament feed
Manual filament feed
system
Manual filament feed
system
Manual filament feed
system
Speed of cutting filament
rpm
11,500
9,800
8,500
Weight
kg
3.1
3.2
3.4
Sound pressure level L
pa
1)
Uncertainty k
pa
dB(A)
80.4
2.5
79.3
2.5
80.1
2.5
Sound power level L
WA
2)
measured / guaranteed
Uncertainty k
WA
dB(A)
92 / 96
X.X
91 / 96
X.X
90 / 96
X.X
Hand / arm vibration a
vhw
1)
Uncertainty k
a
m/s
2
2.0
1.5
3.6
1.5
3.0
1.5
Measuring process complying with:
1)
EN 50636-2-91
2)
RL 2000/14/EC
The stated vibration emission value has been measured according to a standardized test
pro cedure and can be used for comparison of one electric power tool with another. It can also
be used for preliminary evaluation of exposure. The vibration emission value can vary during
actual use of the electric power tool.
7. TECHNICAL DATA
8
GB
