6.3 Information messages
The information messages in the table below are shown in the display of the product. Speak to your Flymo
representative if the same message shows frequently.
Message
Cause
Action
Low battery
The product cannot find the charging station. Change the position of the guide wire. Refer
to
To install the guide wire on page 19
.
The battery is at the end of its life cycle.
page 33
.
The antenna of the charging station is defec-
tive.
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
lamp in the charging station on page 40
.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Clean the charging plates and contact plates.
Refer to
To clean the charging plates and
. If the problem
stays speak to your Flymo service.
Settings restored
A
Reset all user settings
has been done.
Usual operation of the product.
Guide not found
The guide wire is not connected to the charg-
ing station.
Connect the guide wire to the charging sta-
page 19
.
Damage in the guide wire.
Replace the damaged section with new
guide wire.
The guide wire is not connected to the boun-
dary loop.
Connect the guide wire correctly to the boun-
dary loop. Refer to
on page 19
.
Guide calibration
failed
The product has not calibrated the guide wire
because of an error.
Install the guide wire correctly. Refer to
install the guide wire on page 19
.
Guide calibration
done
The product has calibrated the guide wire.
Usual operation of the product.
Connection changed
New loop signal changed.
Usual operation of the product.
1392 - 007 -
Troubleshooting - 39
