Maintenance
After you have finished using your trimmer follow the pro-
cedure below:
1.
Disconnect from the mains electricity supply.
2.
Never clean your trimmer with water, cleaning fluids, or
solvents, just remove debris with a suitable tool, a soft
brush or dry cloth.
3.
Using a soft brush, clean around the inside of the
safety guard, the cutting head and the motor housing
air vents. (Fig T, V).
4.
Inspect the trimmer carefully, especially the parts of
the cutting head.
5.
If your trimmer is damaged in any way contact your
local approved service centre.
•
Never use a damaged trimmer.
6.
Store in a cool, dry place and out of reach of children.
Cable Storage
1.
Your mains cable can be stored on the product as illus-
trated in Fig W.
2.
Wind cable carefully to avoid kinking.
Fault Finding Chart (Automatic Line Feed only)
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
CHECK
ACTION
Is the automatic line feed working?
Manually feed out line.
Is the line fed out and visible? Has
line been removed from cleat?
Remove cap and spool, free line
and re-fit spool and cap.
The line may be jammed on the
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Is the manual line feed working?
Has too much line been fed out?
Rewind line.
Contact your local approved Serv-
ice Centre or Husqvarna UK Ltd.
Customer Service.
Is the line cutter missing from the
safety guard?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558 UK
1800 882 350 ROI
No
No
No
Yes
Yes
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Has the motor reached full speed
before use?
No
Allow the motor to reach full speed
before use
Are you using the trimmer correctly?
?
Only use tip of nylon line to trim.
Is the line jamming on the spool?
Yes
Rewind the line on the spool, if symp-
toms still persist, change spool and line.
T
V
Environmental Information
• Awareness of the environment must be considered
when disposing of ‘end-of-life’ product.
• If necessary, contact your local authority for disposal in-
formation.
The symbol on the product or on its packaging indi-
cates that this product may not be treated as household
waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of cor-
rectly, you will help prevent potential negative conse-
quences for the environment and human health, which
could otherwise be caused by inappropriate waste han-
dling of this product. For more detailed information about
recycling of this product, please contact your local council
office, your household waste disposal service or the shop
where you purchased the product.
W
Replacement Parts
Spool and Line
Reference no.:
FLY021
Part no.:
513937190
Single Spool and Line (Manual Feed)
Reference no.: FLY031
Part no.: 513106090
