Flymo Sabre Power Pack, Manual

Safety

1. Always charge the product indoors and store in a

cool dry place - out of the reach of children.

2. Use only the charger provided with your unit.  Use of any

other charger could permanently damage the Power Pack.

3. Use the charger with standard domestic household

electrical outlets only.

4. Do not abuse the charger or charger cord.
5. Do not use the charger if the charger or charger cord

is damaged.

6. Use the charger indoors only.
7. Do not use the charger outdoors.
8. Do not charge the Power Pack or use the unit in an

explosive or corrosive environment.  Avoid areas
where flammable liquids or gases are present to
avoid creating a fire or explosion.

9. Do not attempt to repair the unit including the Power Pack.
10.Do not incinerate or mutilate the Power Pack. Batteries

contain hazardous chemicals.  Dispose of properly.

If not used properly this product can be dangerous!  This product can cause serious injury to the operator and others,
the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product.
The operator is responsible for following the warning and safety instructions in this manual and on the product. 

Explanation of Symbols on your product

Warning

Read the user instructions carefully to
make sure you understand all the controls
and what they do.

Power Pack

Power Pack Care

1. If over a period of time the Power Pack quickly runs

down after a full 24 hour charging period, a
replacement Power Pack is needed.

2. There will be some charge present in the Power

Pack but to ensure maximum running time, recharge
your Power Pack for 24 hours before use.

3. Permanent connection to the charger in a well

ventilated area will automatically keep your Power
Pack fully charged ready for use.

4. To prevent permanent Power Pack damage, never

store in a discharged condition.

5. Contact your local approved service

centre/dealer/distributor for a replacement Power
Pack and for safe disposal of your old Power Pack.

6.

Power Pack

24 Volt 4.5 Amp/Hour         "High Power"
Sealed for Life                    No maintenance
required

• IMPORTANT

DISPOSE OF YOUR OLD POWER PACK SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE. 

Power Pack Replacement

Your Power Pack is non-servicable.  Should your Power
Pack need to be replaced contact your local approved
service centre or dealer who will replace your old Power
Pack with a genuine Flymo replacement Power Pack.

Winter Storage

1. Fully charge for 24 hours before winter storage.
2. If you are unable to leave your Power Pack on

permanent charge, re-charge the Power Pack every
3 to 4 months for a full 24 hour charging period to
top up the Power Pack charge during winter storage.

3. Avoid extended storage without re-charge.
4. Store in a cool dry place.

Charging the Power Pack
• IMPORTANT !

Switch charger off at the socket before connecting or
disconnecting the Power Pack to the charger

Initial Charging Procedure
•

The Power Pack should be charged for 24 hours
before use.

•

Re-charge your Power Pack immediately after
every use for the full 24 hour charging period.

•

The Power Pack can be left connected to the
charger permanently, with the charger switched
on, without fear of overcharging.

•

The charger will automatically keep the Power
Pack topped up with charge during storage and
will ensure that the Power Pack is ready for use.

1. Use the charger indoors only. 
2. Ensure the charger is not exposed to moisture.  Keep

the charger and the Power Pack dry at all times.  Keep
the charger well ventilated during charging.

3. Ensure the Power Pack is correctly located into the

charger .

4. Plug the charger into a suitable household electrical

wall socket and switch on.

5. The indicator lamp glows continuously during charging.
6. Full charge will be achieved in 24 hours.  During

charging the charger becomes warm.  This is normal
and means the charger is operating correctly.

Re-Charging Your Power Pack

1. Re-charge the Power Pack as soon as the cutting

power of your product begins to die and slow down.

2. Avoid running the product into "deep" discharge, i.e.

avoid flattening the Power Pack completely.

3. Follow the procedure outlined in the 

Initial

Charging Procedure.

4. Charging the Power Pack according to these

instructions should ensure maximum Power Pack life.

Environmental Information

Husqvarna Outdoor Products are manufactured under
an Environmental Management System (ISO 14001)
using, where practical, components manufactured in the
most environmentally responsible manner, according to
company procedures, and with the potential for
recycling at the end of the products’ life.  
• Packaging is recyclable and plastic components have

been labelled (where practical) for categorised recycling.

• Awareness of the environment must be considered

when disposing of ‘end-of-life’ product.

• If necessary, contact your local authority for disposal information.

BATTERY DISPOSAL

• The battery should be taken to an Approved Service

Centre or your local Recycling Station.

•

Do NOT dispose of used battery with household waste

•

Do NOT dispose of battery to water.

•

Lead/Acid batteries can be harmful and should be

disposed of through the recognised recycling
facility in accordance with European Regulation

•

Do NOT incinerate

The symbol        on the product or on its packaging
indicates that this product may not be treated as household
waste.  Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment.  By ensuring this product is disposed of
correctly, you will help prevent potential negative
consequences for the environment and human health,
which could otherwise be caused by inappropriate waste
handling of this product.  For more detailed information
about recycling of this product, please contact your local
council office, your household waste disposal service or the
shop where you purchased the product.

ENGLISH - 1