7
4.4 Stick Calibration
4.5 Power Off
Danger
• Make sure to disconnect the receiver power before turning off the transmitter. Failure
to do so may lead to damage or serious injury.
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Press and hold to turn off the transmitter.
Note: If the pop-up window indicates that the calibration has failed, it means that the control
to be calibrated has not reached the maximum and minimum travel range, the recalibration
is required.
The calibration is required in case of data offset of the transmitter due to physical wear in long-term operations. At
this time, we need to calibrate the output data and neutral angle of the stick, throttle trigger, and potentiometers.
The transmitter has been calibrated at the factory. If you need to recalibrate it, please follow the steps below to
perform the settings
:
1.
Power on the transmitter, enter the
TX SET
menu, and select the
CALIBRATION
function. Follow the prompts to press the
START
for
calibration.
2.
Swing the sticks to the maximum and minimum travel range in each
direction respectively and then release them.
3.
Tap
CALIBRATION
to exit the calibration interface. The calibration is finished.
