21
This function can be used to adjust the output speed of some channels for a specific model. For example, in the
landing gear retraction, users may want it to be opened slowly, therefore, you can slow down the output speed of
the corresponding channel.
For some models with complex functions, we provide up to 10 channels of output, 6 of which are auxiliary channels
for the most effective control of multiple functions in different ways. The AUX CH(auxiliary channel) function is used
to set the control settings for CH5 to CH10, assigning targeted controls to the channels for operation.
To set the step value of the trims.
MIXES is enabled for some models that require two channels to act in linkage. For example, you can perform rudder
compensation so that the aircraft will not lift its nose when throttling up. This transmitter provides up to 8 groups of
mixes.
Function settings:
1.
Select
CH SPEED
and press
Scroll Wheel
to enter
.
2.
Set
ON
or
OFF
to turn on or turn off using
Scroll Wheel
.
3.
Set a switch. In the menu, select a switch and its corresponding position
to finish, or you can toggle the corresponding physical switch on the
transmitter to finish.
4.
Set a speed value
.
Press
EXIT
to save and exit.
Function settings:
1.
Select
AUX CH
and press
Scroll Wheel
to enter
.
2.
Select a auxiliary channel and press
Scroll Wheel
to enter the switch
assigned menu
.
3.
Set a swicth
.
Press
EXIT
to save and exit.
Function settings:
1.
Select
TRIMS
and press
Scroll Wheel
to enter
.
2.
Select a trim you want to set and press
Scroll Wheel
.
3.
S
elect an appropriate value then press
Scroll Wheel.
Press
EXIT
to save and
exit.
6.4.4 GENER MENU - CH SPEED
6.4.5 GENER MENU - AUX CH
6.4.6 GENER MENU - TRIMS
6.4.7 GENER MENU - MIXES
STATUS
To set whether to enable the function.
SWITCH
To set a switch which is to control the
MIX
.
M(Master)
To set a master channel, this channel will control the slave channel.
S(Slave)
To set a s
lave
channel, this channel will be control the master channel.
NOR(Normal)
To set how much the slave channel will move when the master
channel moves in HIGH end. The adjustment range is from-100% to100%. If the
value is set to 50%, when the output of the master channel is 100%, the output
of the slave channel is 50% at the time.
REV
(Reverse)
To set how much the slave channel will move when the master
channel moves in LOW end. The adjustment range is from-100% to100%. If the
value is set to 50%, when the output of the master channel is -100%, the output
of the slave channel is -50% at the time.
