FS-ST8
Digital Proportional Radio Control System
10
6.1 Transmitter settings
There are 11 function menus in TX SET menu: MODEL, TRAINER, STICK MODE, CALIBRATION, SYSTEM SETTINGS,
TIMERS, SWITCH SETTINGS, FIRMWARE UPDATE, ABOUT, HELP CENTER, MORE and FACTORY RESET.
In the main menu, press MENU to enter the function menu. Selec TX SET by scrolling
Scroll Wheel
and
p
ress
Scroll
Whee
l
to enter.
6.1.1 TX SET - MODEL
The MODEL menu is used for model management. It includes five options: MODEL SELECT, MODEL NAME, SELECT
TYPE, MODEL COPY and MODEL RESET.
SELECT MODEL
The transmitter can save up to 20 sets of model data, and you can call out one set of model data at
any time and use it as needed.
MODEL NAME
The name of the model you select can be edited and changed.
SELECT TYPE
To provide a total of 9 different types of models, and it covers most of kinds of the models.
MODEL COPY
If you have a new model that is the same or similar to the model you used before, you can use this
function to make a copy for quick setting.
MODEL RESET
It means that this function will reset all the set values of the model parameters and restore the factory
settings.
Function settings:
1.
In the
MODEL
menu, select the function by scrolling
Scroll
Wheel
and press
Scroll Wheel
to enter the corresponding
next-level menu.
2.
In
the
MODEL SELECT
menu,
scroll
Scroll Wheel
to select
an appropriate model and press
Scroll Wheel
to confirm,
then press
EXIT
to save.
3.
In
MODEL NAME
menu,
scroll
Scroll Wheel
to select an
appropriate
alphabet or number. Use
DELETE
to delete
the related characters. To save the settings by
pressing
Scroll Wheel while
SAVE
is in selecting state. It supports
up to 8 characters
4.
In
SELECT TYPE
menu,
scroll
Scroll Wheel
to select an
appropriate type and press
Scroll Wheel
to finish.
•
If the Helicopter is selected, a swash setting menu
comes along with it, select an
appropriate swash, then
press
Scroll Wheel
to finish.
5.
In
MODEL COPY
menu,
scroll
Scroll Wheel
to select the
model for
FROM
and
TO
respectively, then select
COPY
and press
Scroll Wheel
, a pop-up menu come along with
it. Select
OK
and press Scroll Wheel to confirm. Press
EXIT
to save and exit.
6.
For
MODEL RESET
, select
OK
and press
Scroll Wheel
to
confirm in the pop-up menu appeared.
