FS-ST8
Digital Proportional Radio Control System
26
The following instructions explain how to change the non self-return to self-return.
8.2 Throttle Spring Installation
2
4
5
1. Take the transmitter apart and remove the gimbal,
then remove the two screws which are shown
above and remove the bracket.
2. Loosen the assembly screws shown above first,
then remove the plate assembly. Be careful to
ensure no damage to cables.
3
3. Insert the 2 dowels as shown above.
4. Place the spring hook assembly into position and
hook the spring onto the hook located inside the
transmitter.
5. Place the plate assembly back in its original
position, then secure it with the original 4 screws.
