8
Function Settings:
By adjusting the screws on the back of the transmitter, gimbal stick can be either self-return or non self-return, as
well as changing stick tension/friction.
Available options:
CAUTION
• When the counterclockwise adjustment is made， the entire range of movement of the
screw is about 6 circles(the tightest to the loosest). Be cautious not to adjust it too far
or the screw will fall out.
Take left gimbal as example:
Non Self-return to Self-return:
Self-return to Non self-return:
① . ⑤
To change the gimbal sticks self-return or non self-
return.
② . ⑥
To change vertical tension strength of
the gimbal sticks.
③ . ⑦
To change horizental tension strength of the gimbal
sticks.
④ . ⑧
To change the vertical friction strength
of the gimbal sticks
1. Use a Phillips screwdriver to adjust the screw
①
counterclockwise until the gimbal reaches its
median position.
2. Adjust screw
④
counterclockwise to adjust the frictional strength.
3. If you need to adjust the strength of the return, adjust screw
②
to change the strength of return to
the median position, and to strengthen the strength clockwise, otherwise it's to reduce.
1. Use a Phillips screwdriver to adjust the screw
①
clockwise so that the gimbal is no longer at its
median position.
2. Adjust the screw
④
clockwise to strengthen or reduce the frictional strength.
3. If you need to adjust the strength of the return, adjust screw
②
change the strength of return to the
median position, and to strengthen the strength clockwise, otherwise it's to reduce.
3.2.4 Stick mode
This system supports four stick modes. As for aircraft models, from channel 1 to channel 4, by default, these four
channels are assigned to aileron, elevator, throttle, and rudder. There are four preset modes of the sticks in order
to meet the different requirements. You can select suitable mode among
Mode1
,
Mode2
,
Mode3
and
Mode4
. The
green icon indicates the currently selected mode, and the default mode is
Mode 2
. You can select suitable mode as
your desired. Then you need to adjust the gimbals as needed to match the mode. Follow the steps below.
Function Settings:
Enter the Model Setup interface via
Home1
>
Basic
>
Model
,
then tap the function box next to
Stick
to enter the stick mode.
Select the mode as your desired. Then click to return.
3.2.5 Gimbal Adjustment
Be used to adjust the states of sel-return and resilience strength of the 5D multiplex stick.
Back View of gimbal
Viwe of Stick's Swing
①
②
③
④
⑤
⑥
⑦
⑧
Note: It is also can be set in updating wizard interface after the transmitter
firmware is updated. The factory preset mode for the stick can be set in this
interface. Only transmitter firmware version 1.0.55 or above has this function.
