10
Make sure that the receiver is mounted in an appropriate location within the model, to ensure a stable signal,
maximum range and to mitigate external interference, follow these guidelines:
Pay attention to the following when installing the receiver:
1.
1. Make sure the receiver is not installed near ESCs or other sources of electrical noise.
Make sure the receiver is not installed near ESCs or other sources of electrical noise.
2.
2. Keep the receivers antenna away from conductive materials such as carbon or metal. To ensure normal
Keep the receivers antenna away from conductive materials such as carbon or metal. To ensure normal
function make sure there is a gap of at least 1cm between the antenna and the conductive material.
function make sure there is a gap of at least 1cm between the antenna and the conductive material.
4. Pre-operation Setup
Follow the instructions and guidelines in this chapter before use.
4.1 Receiver and Servo Installation
CAUTION • To prevent damage do not power on the receiver during installation.
