20
7.2.5 Deleting a model
To remove a model from the memory of the transmitter .
Function setup:
1. Enter
Select model
interface.
2. Tap the model that you want to delete.
3. Tap
Delete
and click
Yes
on the pop-up interface to
complete. Afterwards, Tap to return to the previous
interface.
Note: The model currently in use can not be deleted.
7.3 Model Setup
PL18 transmitter includes a variety of options for modes, including Airplanes, helicopters, gliders, multicopters,
cars, boats and robots. You can set the related settings of models, such as configurations and functions.
DANGER
• Before operating, make sure to check whether the status of each channel is safe. If the
channel is not in safe state, this may lead the destroy to the structure of the airplane. Or if
the model airplane starts directly, it may lead to personal injury or other accidents.
Tap to reset all data of the model.
Shows the corresponding item, after
the model category and model sub-
configuration have been selected.
Note: For Airplane/Glider, Tap the area to
enter Wing and Tail setting interface. For Car/
Robot, to enter move setup interface, and
for Helicopter, to enter Swash plate setting
interface. While for Ship and Multicopters,
nothing is displayed here, and you cannot Tap.
Tap to enter the interface of selecting
model picture.
Tap to enter the interface of renaming
model's name.
Model Categories
Show the default piture of the model.
Model sub-configuration
The function item is different
due to different model category.
Tap to enter the interface of selecting
stick mode.
Tap to enter the interface of selecting
model type.
Tap to enter the interface of selecting
wing,tail and optional functions.
Note: This function is available for version 1.0.65 or above.
Model type setup
Sets model type and related parameters and functions. For
Airplane/Glider
, you can set
Wing
,
Tail
and
Optional
.
For
Helicopter
, you can set
Swash plate
and
Optional
. For
Car
and
Robot
, you can set
Move setup
and
Optional
.
Note: If the model type is changed, the model data will be reset and the sub-configuration will be changed, as well as the function assign
interface will be changed accordingly.
