22
For Helicopter, follow the
steps below to
change the
swash plate type
.
1. Enter
Model setup
interface.
2. Tap
H-1
.
3. Tap the appropriate swash plate according to the
actual model. Afterwards, click to return to the
previous interface.
For Car or Robot, follow the
steps below to
change the
move setup
.
1. Enter
Model setup
interface.
2. Tap
Humvees
.
3. Tap the appropriate item according to the actual
model. Afterwards, click to return to the previous
interface.
Normal: Indicates that the channel output is the default direction.
Reverse: Indicates that the channel's direction has been reversed.
Notes:
1. If a new model is connected, make sure the corresponding channel of the
servo is correct.
2. Move the stick, switch or knob related to channels to make sure that the
direction of each channel is correct.
Function setup:
Tap the box at the right of the channel name to toggle reverse for
that channel. If there is a tick in the box it means that the channel
is reversed.
7.4 Reverse
To reverse the output direction of each channel.
This function can be used to correct the direction of the servo action which is opposite to the intended operation.
Due to different servo types or servo installation methods, servo directions can be set for 18 channels.
