32
Installation steps:
1. Turn on the transmitter and enter
Home1
>
Basic
>
Sensor
. If the sensor displays External Voltage data,
then installation is complete. Otherwise repeat the
above steps.
2. Connect the FS-CVT01 sensor to the
SENS
interface
of the FTr10 receiver.
3. Insert the red and black wire pins into the port on the
battery. Red is positive and black is negative.
Note:
Ext voltage
means the sensor is testing the voltage;
3.2V
is
the measured voltage value.
FS-CVT01 voltage acquisition module
The FS-CVT01 function is used to monitor the model battery voltage.
FS-CAT01 altitude pressure sensor
To detect the altitude and of the model.
Installation steps:
1. Connect the FS-CAT01 sensor to the
SENS
interface
of the FTr10 receiver.
2. Use double sided soft tape to snugly fix the FS-
CAT01 sensor in place.
3. Turn on the transmitter andenter
Home1
>
Basic
>
Sensor
. If the sensor displays
Height-PR
data, then
installation is complete. Otherwise repeat the above
steps.
Note:
Height-PR
means the sensor is testing the altitude;
14m
is
the actual measured height value.
The function setting of FS-CVT01, refer to descriptions above.
Function setup:
1. Tap
Hg zero
to clear the value of altitude or set a
switch to clear it.
2. Tap to turn on/off the prompt voice. Or set a
switch to turn on/off the prompt voice
,
click to
return to the previous interface.
The interface of the
Height-PR
is shown at the right.
For the
Alarm
and
e
xtreme value
, refer to the related
setting of the
TX voltage
. For the setting of
Height
,
follow the steps below:
To display the real-time value of
altitude and atmospheric pressure.
Tap to clear the value of altitude.
Tap to turn on/off the prompt voice.
Notes:
1. The altitude sensor collects the changes in the barometric
pressure to determine the altitude. Airflow changes can cause
some errors in monitoring.
2. When the volume of the beep is higher, it means the aircraft is
ascending, and when the volume is lower, it means the aircraft
is descending.
