34
7.11 RF setting
Set and display RF-related parameters/data, e.g., enable/disable RF function, type of RF, RF module firmware
upgrade, RF module related information, etc.
7.11.1 Transmit
7.11.2 RF set to be on by default
7.11.3 RF Type
To enable or disable transmit function. If you don't need
the transmit function, e.g., the transmitter works as a
USB emulator, you can disable the transmit function by
this function.
Used to set whether to enable transmit function when the
transmitter is turned on. If the check box is not selected,
the transmit function will not be enabled when the
transmitter is turned on. If you need to use it, enable the
transmit function via this interface.
Used to select an appropriate RF type as per the
communication protocol of the receiver to bind to the
transmitter.
FRM301
(classic receiver) and
FRM302
(enhanced receiver)
adopt AFHDS 3 protocol;
PPM
is for RF module using PPM
protocol, and
CRSF
for
RF
module using
CRSF
protocol.
Function setup:
Click the check box next to the
Transmit
. "
√
" means
the function is activated.
Function setup:
Click the check box next to the
RF set to be on by default
.
"
√
" means the function is activated.
Function setup:
1. Click
RF type
to enter the setting interface.
2. Tap the appropriate RF type and click
Yes
on the pop-
up interface to complete. Then click to return to the
previous interface.
Note: For safety, the RF function cannot be disabled if the receiver is
turned on.
