36
7.12 RX setting
Information about receiver functions. It can be used to set various functions before the receiver is ready for work.
7.12.1 Bind setting
7.12.2 Custom port protocol
This function is used to adjust the transmitter to the bind
state and so as to bind with the receiver.
Refer to
5.2 Binding
for detailed bind operations.
Sets the type of output signal of the receiver interface. This screen
shows on the left side the interfaces that can be set, and, on
the right side, the protocols that can be set. Only the enhanced
receiver supports the output of i-BUS2 protocol signals.
Enhanced receiver
:
When no receiver is connected, 4 Newport
interfaces are displayed by default for setting; When a receiver is
connected, the Newport interfaces that can be set on this receiver
are displayed.
Classic receiver: When no receiver is connected, i-BUS/Servo and
CH1 are displayed by default; When a receiver is connected, the
interfaces that can be set on this receiver are displayed.
Function setup:
1. Tap
Custom port protocol
to enter the setting
interface.
2. Tap the Newport you want to set, such as
NPA
.
Then click the appropriate protocol.
3. Click to return to the previous interface.
⑴
⑴
⑴
⑵
⑵
⑵
⑴
Tap to select the newport:
NPA
,
NPB
,
NPC
or
NPD
.
⑴
Tap to select
i-BUS/Servo
or
CH1
.
⑴
Tap to enter the port protocol setting menu for
primary RX.
⑵
Tap to select the signal type for newport: PWM,
PPM, S.NUS, i-BUS-IN, i-BUS-OUT or i-BUS2.
⑵
Tap to select the signal type for i-BUS/Servo or CH1.
⑵
Tap to the port protocol setting menu for
secondary RX.
Note: Neither classic receiver nor enhanced receiver supports i-BUS-IN
setting in one-way communication. More notes are as below:
Enhanced receiver:
•
For double receivers, you can set the type of output signals for the
interfaces of the primary and secondary receivers separately. However,
the secondary receiver does not support external sensors. Therefore,
the interface protocol cannot be set to i-BUS-IN.
•
The signal types that can be selected once only in multiple for any
Newport: PPM, S.BUS, i-BUS-IN and i-BUS-OUT. If it is selected for NPA,
i-BUS-OUT cannot be selected again for NPD/NPC/NPB.
•
If i-BUS is selected for any Newport, i-BUS2 cannot be selected for any
other Newport; If i-BUS2 is selected for any Newport, i-BUS cannot be
selected for any other Newport. For i-BUS2 and PWM, Newport can
select them repeatedly.
•
If you have bound double receivers, you can set the interface protocol
of the primary and secondary receivers separately.
The screen of Custom port protocol is for enhanced RX.
The interface of Custom port protocol is for classic RX.
The interface is for double receivers are bound.
Note: This function is available for version 1.0.45 or above.
New items are added to this function for enhanced receivers.
