45
7.12.13 i-BUS setting
This function is used to set the external device with
supporting i-BUS protocol, and the Serial Bus Receiver
and Voltage sensor can be set currently.
Serial Bus Receiver FS-CEV04 setting
After the setting is completed, FS-CEV04 can convert i-BUS
signal to PWM signal and output.
FS-CVT01 Voltage sensor calibrating
A calibration factor can be set to correct the voltage
value returned by the i-BUS voltage sensor FS-CVT01.The
calibration factor is stored in the transmitter and shall be
recalibrated when the battery type is changed.
Refer to 7.9 Sensor FS-CVT01 for the description of function
setup.
Function setup:
1. Make sure the transmitter and receiver are bound.
2. Connect the FS-CEV04 to the SERVO port on the
receiver.
3. Connect a servo to one of the C1-C4 ports on the FS-
CEV04.
4. Power on the transmitter and navigate to the
i-BUS
setup
function item located in the
RX setting
function.
Select the channel you want to assign, if it is wrong,
click
Cancel
to cancel it.
5. Press the corresponding button. After the channel
assignment is successful, a pop-up window will appear.
• If the channel assignment is successful, channel
number and interface number will be displayed.
6. Repeat the steps above for setting more channels.
• If there are too many peripherals attached to the
i-BUS serial bus receiver, power it separately.
Note: During the calibration, the voltage sensor must be connected to a
power supply.
Note: This function is available for
version 1.0.65 or above.
7.12.14 Signal strength output setting
Through this function, you can select a channel to output
the signal strength value of the receiver. After the function is
enabled, the selected channel does not perform the output
of transmitter's corresponding channel function, but outputs
the receiver's signal strength value. This function is necessary
for users who use FPV glasses in the operations of traversers.
We recommend the user to select the 14th channel or any
auxiliary channel. You can make corresponding adaptations
in the flight control settings to view the signal strength
information on FPV glasses.
Tap to enter the interface of selecting channel.
Tap to toggle between on or off.
Function setup:
1. Tap
Select output channel
.
2. Tap an appropriate channel. And it will automaticlly return.
